Technical Forums > VPN Client Setup Support
VPN Enabled, but cannot access services
Hi Guys,

I have setup a vpn with the shrew vpn client to an netgear prosafe firewall.
The tunnel is enabled, but I cannot reach anything on the other side.

Could it be that there is no correct route?
When I enter route print on the client side I see the foloowing:

IPv4 Route Table
Active Routes:
Network Destination        Netmask          Gateway       Interface  Metric
     20         On-link    306         On-link    306         On-link    306         On-link     31         On-link    286         On-link    276         On-link    276         On-link    276         On-link    286         On-link    286         On-link    286     21         On-link    306         On-link    276         On-link    286         On-link    306         On-link    276         On-link    286

local client ip is
virtual network of the shrew client
remote internal network is

Can anyone help me out here?
Message Index

Go to full version